To poster about using small pistol magnum primers, I have done so with 38 spl., and 9mm without any issues. Does not make a difference of any note on chrono in 38 and barely at all in warmish loads for 9mm.
I have some Em excesso CCI 35’s if anybody is looking, but I heard you can’t ship them without a Hazmat license or some BS ??
-the appetite isn’t big for this type of discussion because it usually ends in failure (Meech and Charlottetown)
-the promise of railways to capture the Canadian market, that induced that area to join confederation
There is a local gun dealer here…he refuses to up his prices just becaused he could. This dealer gets AR’s in….sure the AR’s sell fast..but this dealer has been consistant with his pricing and is disgusted by the very types that help fuel these shortges….”The Black Market Scumbags”!
-Premier John Oliver had through the 1920s successfully challenged the federal government over railway freight rates and liquor legislation
A general election is held. This is every 4 years but can happen sooner under website certain circumstances.
a new Union would be federal in character…that the power of the federal government would be national and the power of the provincial would be local
All of these rifle powders are the extruded type IMR 4350 pellet type shown above. If you have some round such as a 30-378 or something similar then you might need something slower, but personally I don’t see much use for such rounds. There are several ways to make reduced loads. One way is to use a powder that is so slow that it can’t build up enough pressure to stress an old rifle. An example is the 45-70 types of cases in black powder guns. A case full more info of 4831 reloading powder won’t generate excess pressure, but make sure there is little or no airspace as that will cause inconsistency and can be dangerous in some instances.
Ball powder burns very cleanly and is temperature stable, making it a good choice for both indoor and outdoor shooting. It is also less likely to clump, making it easier to load into cartridges.
-so in December of 1941, a Liberal resolution endorsed the idea of a coalition government which forced Petulow out
The individual accessing this site assumes the risk of safe loading practices. Failure to do so could result in severe personal injury (or death) and/or property damage.
-the government’s record and popularity of the party tended to be greater than that of the leaders’ themselves
-Petulow rejected the idea of a coalition government, because the ideological differences between them all were too important, therefore no basis for inter-party cooperation